Hard peeling increases the service life of gears

More quiet running and better surface properties 

The hard peeling finishing process can be used for straight and helical gears and enables to manufacture gears of high quality in a short time. Worm gears as well as spur gears are hardened  additionally and the corresponding tooth flanks remilled. Hard peeling eliminates the unavoidable hardness distortions and achieves finer surfaces, resulting in a better surface finish.
Applications with increased demands on installation tolerances and wear are the typical areas of applications for gear components which
are produced by hard peeling

Data & facts about hard peeling at Nozag’s
> Application range: Module 1.0 to 2.5 (3.0)
> Increased gearing quality up to Q6
> Better surface quality (up to Ra 0.15)
> Surface hardness up to 60HRC possible
> Increased running smoothness for gears
> More flexible production possibilities
> Shorter delivery times compared to ground components